Header banner
Revain logoHome Page
πŸ”§ autotoolhome carbide steel tooth metal logo

πŸ”§ AUTOTOOLHOME Carbide Steel Tooth Metal Review

3

Β·

Poor

Revainrating 2.5 out of 5Β Β 
RatingΒ 
2.7
πŸͺš Hole Saws & Accessories, πŸ”ͺ Cutting Tools

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”§ AUTOTOOLHOME Carbide Steel Tooth Metal
img 2 attached to πŸ”§ AUTOTOOLHOME Carbide Steel Tooth Metal
img 3 attached to πŸ”§ AUTOTOOLHOME Carbide Steel Tooth Metal
img 4 attached to πŸ”§ AUTOTOOLHOME Carbide Steel Tooth Metal

Description of πŸ”§ AUTOTOOLHOME Carbide Steel Tooth Metal

TCT drill bit is suitable for hand held electric drill, beach drill,stand motor-driven drilling machine and mobile ribbon type magnetism drilling machine. The gears is made from YG8 tungsten carbide steel and the rigidity varies from 64HRC to 65HRC. Sharp gears and anti-cutting with lower consumption make the product a long service life. The hole saw has a center twist drill bit inside, Can drill about 3/4 inch depth for the wood, and can drill about 3/16 inch thickness for the steel. Carbide teeth for fast cutting of clean, round holes.Driling with stainless steel plate,high alloy steel,iron,aluminum,castings,plastic,metal,wood,etc.

Reviews

Global ratings 3
  • 5
    0
  • 4
    1
  • 3
    1
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

Done cheap, buy something else

Cheap junk. If I could give zero stars I would. When I first used it, this bad boy pulled almost all of my teeth out of the cup before I even got past the halfway point of the steel plate. I'm cutting through a 1/4 thick plate of steel. I used cutting oil and worked slowly, but it still broke. Save money and don't buy. It's advertised as being able to cut metal but it might be good for wood but that's it, maybe aluminum. I was so disappointed as it looked so strong and sturdy when it arrived.

Pros
  • Tools and household goods
Cons
  • There are more interesting options.

Revainrating 4 out of 5

Please. for hole saws and accessories

Her official advice from someone using this hole saw on a drill for the first time: - It makes a very clean hole but wastes as large a circle as it can on a drill be stiff. Take a little at a time. It resonates and makes you scream LOUD (no, really. LOUD). USE HEADPHONES. USE A SPRING. I thought that was stupid and tried my first haircut without it. After that I spent 15 minutes hollowing out a wooden disk - DO NOT TOUCH THE FEATHER. It gets stuck in the wood disc after cutting. Touch it and it

Pros
  • Power and hand tools
Cons
  • Can't remember

Revainrating 3 out of 5

There was a lot of rattling through the 1/8 " steel plate.

I used a hole saw to open the center hole in the 5/16" steel plate sprocket. I tried drilling the hole with a Milwaukee steel tooth hole saw. It boomed hard and stopped cutting completely after a little over halfway. So I needed another hole saw to finish the job. I found this one and it looked very durable and had ceramic teeth. I expected him to easily finish the hole on the other side. It really broke through after running my little drill for almost an hour. It throbbed hard and only seemed…

Pros
  • Hole Saws
Cons
  • I don't remember, but there was something.