🔑 Authentic Evinrude/Johnson/BRP Ignition Key Switch & Safety Lanyard 5005801 - Genuine OEM Component Review

received faster than promised, looks original. However, the failure was not what the Marina had hoped for. It was the starter solenoid, which Marina says never failed. So we sent it back for low shipping cost.

Evinrude Etec 90 HP An old key switch was preventing the kill switch from working properly. You must now have a working kill switch in Florida by April 1st. Installation took less than 10 minutes. Just install one wire at a time, matching old and new. Make sure you set the switch correctly. Flat side up. There is a drain hole at the bottom.

Used this on a 2000 Johnson binnacle so the kill switch lanyards would not stay on. The eyelets on the derailleur are worn causing the lanyard to fall off during operation without stopping the engine. Several straps have been tried without success. Due to mandatory kill switch laws and active lanyard wear, a working kill switch is mandatory. This new switch works just like the original one.

OEM, very happy with the product. Original packaging and manufacturer parts. There are so many unoriginal and misleading ideas about the ignition switch on the internet. Yes, the prices are cheaper. I ordered the "cheaper" option and when I received it the package was in a regular ziplock bag, pre-made label stickers and the product itself was cheap plastic, smaller diameter plug and play pins, poor quality, made in china .return aftermarket for a refund i ordered this ignition switch from this