⚡ BUNKER INDUST 6-10 Gauge 50A Battery Quick Connect Wire Harness Plug Kit Battery Cable Quick Connect Disconnect Plug for Winch Car Trailer Electrical Devices, Set of 2, Grey Review

I ordered this plug because it was marked as ANCHI brand, but I received ATEM POWER brand plugs. The two connectors have minor differences that make compatibility difficult. ANCHI spade lugs marked "A" will not mate with ATEM spade lugs marked "S". In a high current situation, this reduced surface contact area is of great importance. I contacted the seller but he did not reply. The product will be returned to Revain. I give 1 star for an inaccurate product description.

I bought this to mount in line on my electric radiator fan. The previous fork got very hot and eventually failed. This connector is over rated for the fan motor amperage and will hold up well as expected. No instructions were included but there is a YouTube video on how to connect the pins in the connector to battery quick disconnects.

I thought this is what I need. I looked at the installation from You Tube and struggled with the installation for 2 days. The connection on one end simply will NOT "snap" as the video shows! Since the seller ONLY ships bearish low light connectors, I had to be very careful not to make any mistakes. After meticulous processing and repeated grinding, it finally "fitted in". GREAT, I thought. Then I found out that the plug is defective and not working. So. I'll start from the beginning, but I…

These are two identical pieces that fit together when assembled BUT NOT until properly assembled. Silver pins have a tiny hooked edge on one side of the tip. They should match the copper plates in the plastic case. Don't do this until you have connected the wire to the pins as it will be difficult to separate the pins from the copper. The copper is not supposed to conduct electricity, but only as a spring clip to hold the silver pins in place. This worries me because if the connector is ever…

The connector is designed for very heavy duty, high capacity and reliability. However, to install it you will need either a special tool for crimping the cable or soldering the lugs to the cable. You have to do a thing or two to make a good connection. This is a great item, it only requires special assembly. This is really a 5 star item, the only downside is the special assembly. The connector housings are made of thick plastic and are very durable. The only problem you might have is that they…

Very well made and works well. Assembly instructions could be expanded and clearer. They don't show you how the end of the wire goes into the plastic case. If you look closely you can see that the tip is hooked, and this hook is hooked to a piece of metal in a plastic case. After reading the reviews and inspecting the lug, I decided to solder (rather than crimp) the lug. The ferrule is very strong and the crimping method requires a lot of pressure to squeeze the wire hole tight enough to accept

I have an inverter and deep cycle battery in a milk crate that I can put in the back of my truck, UTV etc. I have these connectors and some 6AWG wire so I can connect the portable battery to the larger deep cycle battery installed in my Ranger to get longer usage (more hours plus charging from the Ranger's alternator) from the inverter. The jumper cables I used didn't stay attached and were a little fiddly to attach and detach. These quick couplers are much better. They're easy to…