Header banner
Revain logoHome Page
colorfabb 90 285 133 filament diameter light logo

ColorFabb 90 285 133 Filament Diameter Light Review

3

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.4
🖨️ 3D Printing Supplies, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to ColorFabb 90 285 133 Filament Diameter Light
img 2 attached to ColorFabb 90 285 133 Filament Diameter Light
img 3 attached to ColorFabb 90 285 133 Filament Diameter Light
img 4 attached to ColorFabb 90 285 133 Filament Diameter Light

Description of ColorFabb 90 285 133 Filament Diameter Light

Extreme high flex MODULUS (6.2 gpa) / twice as stiff as PLA with moderate strain at break (8-10 percent ). High glass temp (TG = 80°c) and very high melt strength and viscosity. Low odor / styrene free solution. Colorfabb_xt is produced with Amphora 3D Polymer from Eastman chemical.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 5 out of 5

Amazingly Vibrant Print!

This filament produced vivid and bright 3D prints that were incredibly impressive.The colors pop and create a visually stunning final product..

Pros
  • The print quality and color intensity are top-notch.
Cons
  • The filament is slightly more expensive than other options in the Industrial and Scientific 3D printing supply category.

Revainrating 5 out of 5

Brilliant Filament for Perfect Prints

This filament’s smooth texture makes it easy to work with and produces flawless prints. Thanks to my knowledge gained in practice I can gladly say that the quality of my prints has elevated since switching to this filament. The vivid colors do not fade overtime which makes the final product more vibrant. The only downside is the price but the quality justifies the cost..

Pros
  • High-quality and produces consistently bright and vibrant colors.
Cons
  • Some users have reported difficulty with adhesion and warping during printing.

Revainrating 2 out of 5

Poor adhesion on Ender 5.

I bought clear filament. Very bad grip with Ender 5. There were also a lot of traffic jams. I had no problems with the other thread. I spent 2-3 hours getting this to work. Tried 240-260°C in increments of 2 on the hot end, and for the build plate I experimented with 60-70°C.

Pros
  • Additive manufacturing products
Cons
  • unreliable