🔪 DCT Inch Sharpening Stone Holder: Enhance Precision and Stability in Your Sharpening Routine Review

EFFORTLESS SHARPENING: The DCT 5.5” to 9” Inch Sharpening Stone Holder – For Diamond, Shapton, Glass, Oil, Wet Knife Sharpener Honing Sink Stones safely secures your sharpening stones firmly in place to allow precise, sharp edges on your blades and planes; Rubber body keeps entire unit stabilized on your work surface and tightly holds your sharpening stone to prevent any sliding. ACCEPTS MOST STONES: Whether you are reprofiling a blade with an aggressive stone or doing fine touchups, this holder provides a solid stable base to work on and facilitates hand-held use or can use on top of a sink bridge while sharpening; Sharpen chisels, plane irons, and more with diamond plate, natural stone, glass stone, oilstone, whetstone; Keeps your stone from moving even when working in a wet, slippery area; Stone not included. ADJUSTABLE FIT: Fits stones from 5.5-inches to 9-inches (14cm to 22.9cm) long; Knurled nuts tighten and loosen grip for easy adjustment to fit a variety of sized stones; Rubber end caps are removable to rearrange middle and end block to accommodate even shorter stone lengths; The 3 rubber pads are each 2.75 inches (7cm) wide and end pads have a 0.25-inch (6mm) tall lip (11.5” x 1.25” x 2.75” inch / 29.2cm x 3.2cm x 7cm overall dimensions). CHANGE QUICKLY: Threaded to easily swap out different sizes and grits of stone including an 8-inch x 3-inch water stone to a 2-inch x 6-inch diamond plate by spinning the knurled adjustment knobs open, removing the first stone, placing second stone, and adjusting fit. BUILT TO LAST: Chrome-plated arms for rust-resistance; Rubber body features non-marring weighted grip feet and keeps stones from sliding; Rubber stops are contoured to keep your sharpening stone securely in place without damaging the stone or surface