Dorman 924-307 Trailer Hitch Plug: Superior Quality in Sleek Black Design Review

Correct price and perfect replacement for my 2007 GMC 2500 Classic. Remove the cable - Disconnect the old one (spin it), remove it, add some dielectric grease, seat Insert the new one into the factory bracket, rotate and reconnect the wiring harness. Start by completing 15 minutes when you take the time to clean and lubricate the joint. Less $ than big stores and easy exchange.

We had some trouble connecting our right tail light for the fifth wheel and still had the original trailer connector. So I figured this would be the solution and when I saw it I bought it for the low cost and easy replacement. It was very easy to replace. It turned out that our taillight problems were due to bad contacts in the RV taillight wires and this was fixed with WAGO wire connectors. The other one was so old, I'm glad we replaced it! I hope the new one will last as long as the original!

Plugs directly into 2006 Silverado 1500 OE connector. It doesn't feel cheap and doesn't look like it's about to break. All you have to do to replace this is look at the connector on the truck and find the 2 tabs (plastic tabs) that should be visible from the bumper and twist the socket on the back and the Plug should come out straight. Remove the connector on the back, reinsert the connector and reverse the process. Done and done. There is no rewiring or fiddling required to connect a different

This is a Pollak in a Dorman box. Pollack speaks directly in front of him. Fits/works well but make sure you buy two at the best price as they are the exact same device. Easy to install. I have a 10 year old Ohio Corrosion. Press the tab and the strap will pop out instantly (dirt will fall off). To pry the old block out, press down on the latch with a flat head screwdriver (it will most likely break, no big deal). Turn counterclockwise facing the rear where the factory wiring harness is…

Installed on a 2002 GMC Duramax Diesel 2500HD. I bought it new 208,000 km ago. He is 17 years old and the plastic plug from the trailer has been used many, many times. The flap door has come loose and is actually holding the trailer fork. So I went to the auto repair shop to buy a station wagon, cut the wires and install it. But checked here to see if the plug is cheaper as I hate car dealerships. They don't care about you because they answer the phone all the time. For example, can the guy on…

Perfect fit and restored lost function. The cover on my original trailer connector ripped and no longer held onto the hinge pin. I ran it without a cover for a while, but water got in and ruined the wiring, causing corrosion around the pins. I was able to keep the outside surfaces clean and it worked for a while, but eventually I started having problems with the cable connector. Symptoms included not showing a reverse light all the time (preventing the brake disc lock from working which…