🔧 DD350X Drill Bit Sharpener by Drill Doctor - Multi-Purpose Tool, Pack of 1 Review

This device is much easier to use than a drill sharpener that is over 40 years old. The instructions sounded complicated, but once I laid the sharpener down in front of me and read the steps one by one, everything was easy. This is a great accessory to take care of my instruments.

I wasn't sure about this product but the price was good. The first time I used it, I hit the reel and ended up sharpening 88 bits. Pays for itself the first time you use it. It's nice to have good sharp baits again and not have to worry about blunt baits as I can always sharpen the tips. Great tool!

I've been working on several projects lately and I've been working like crazy on the drill press. They dull so quickly that I get frustrated and just push harder until they break. With this device, I can drill until I feel wear, stop for a minute, touch up the edge, and carry on like it's a new drill. What a money and time saver! I highly recommend.

I would advise a manufacturer not to sell any product unless the instructions and design clearly support those instructions. The instructions and online videos have totally confused me on how to insert and secure the drill bit in the correct position, it's more of a manual process on this model. Their $100 version of this tool is good and easy to set up. I wouldn't put this version up for sale at all, it needs revision for the buyer to understand. I do not recommend.

I regularly drill holes in blocks of wood and brass to make knife handles. I have quality drill bits that I bought years ago but over the years they have dulled a bit and need sharpening. This sharpener works like magic and gives my bits a better edge than when I first bought them. It took me a while to figure out how to use this machine properly, but once I did, keeping my bits sharp became a very quick and easy process. I am very happy with this purchase and would recommend it to anyone who…

I don't have any problems with the instructions like other buyers. In fact, the manual is pretty clear what the problem with this product is. I can grind the thigh down on one side, but when I get to the other side, the screw is fully seated in the chuck again. According to the instructions, this is because the bit is not being held properly. The only way I see a tighter chuck clamp is to use a bench vise or vise, which will eventually break the chuck due to the type of soft plastic it's made…

I bought this to sharpen a box of bits. He did exactly what I wanted. The beats are all sharp now. My bits have been used for about 30 years and are usually replaced with new bits that cost more money. This one time purchase should have been made sooner if I knew it would work so well. shaky, but if you go online to watch youtube videos I think you will get very clear how to use it. Once you sharpen a little or two it becomes very easy. I think the value is definitely worth it. FYI, I have a…

. If you can read and understand instructions. Of course there is a learning curve. You must understand the terminology and relationships of machine parts and how they are used. But it's not that hard if you follow the instructions that come with it. After a few trial runs to make sure I was setting the bit correctly, everything went smoothly. In hindsight, it's pretty reliable. Took about 15 minutes to sharpen 4 bits that were very dull. I mean so boring they just twirl around in the pine…