🔧 Blue Stars Ultra Durable 279834 Gas Valve Ignition Solenoid Coil Kit: Premium Replacement Part for Whirlpool Kenmore Maytag Dryers – Easy Install, Exact Fit – Replaces AP3094251 PS334310 12001349 Review

available As a number of part failures may not cause heat (e.g. igniter, flame sensor, thermal fuse, thermostat or two or coils) to find out which one is defective, some force may be required. Almost all of these are easy to test once you're inside, but gas coils don't seem to have a simple electrical test like resistance. From what I have read the gas coils should be replaced when the dryer starts and initially shows a burning flame but does not reignite (even with the igniter lit) when the…

My wife noticed the smell of our dryer (a bit like gas) and noticed that our clothes weren't drying as quickly as they used to be. I told her to call someone. She said - I did - I called you. I removed the front cover from the dryer and everything seemed to work. The flame was very strong, but I didn't have anything like it. I also noticed that the flame kept going on and off. I've watched several diagnostic videos on YouTube. All signs pointed to those valves being the problem and with $9…

Item received very quickly! This was my second attempt at repairing our gas dryer (Kenmore Elite - about 9 years old). After cleaning the lint filter, blowing out the vent in the wall, and replacing the thermal fuse, it still didn't work properly. You could hear the pilot turn on after a minute and the dryer would heat up for about 5 minutes then it would start buzzing without heating up and it sounded like the pilot was trying to light itself up again. The top panel does not need to be…

As my dryer is a Maytag Neptune the installation of these coils was very easy and straightforward. The swap only took a few minutes and I checked the resistance of the new coils with my multimeter before installing them to make sure they weren't bad. After installation, I reinstalled the door and checked the wet laundry. With the front of the dryer open, I was able to fully observe the cycle from start to finish. The coils seem to be doing their job and the charge ended after half an hour…

so basically i initially had intermittent gas fires, it burned for a few minutes and then shut off. One guy claimed it was the igniter so I replaced it, it did the same thing, burned out for a few seconds and shut off. So most said they should change those solenoids. These things cost between $6 and $11. I chose them because they were chosen by Amazon but when I received them they looked like all the other parts, probably made in China. However, disconnect the dryer from the mains. You will see

Parts arrived in 10 minutes today, my Maytag gas dryer model #LDF512 was working again. There may be a problem with my Maytag dryer. The dryer has been the workhorse for the last 12 years. I replaced my dryer fan wheel about 3 years ago because it was making a horrible noise when it turned on. Thanks, YouTube helped me replace this part. Now my symptoms were clothes not completely dry, dryer heats up intermittently, ignition is on and gas is on for a while (5 minutes) but then shuts off. out…

This did a great job fixing my dryer and I only had one small issue with it which I later addressed will explain. I will describe my symptoms below so others can see my situation and decide if they need this detail. I have a whirlpool dryer that is included in my home rent but is not "covered" or guaranteed by the landlord. It's (obviously) a gas dryer. It's pretty basic, but it has a sensor-based setting (hot or cold) as well as a default timer-based setting. That's pretty much all a dryer can