🚀 Enhance Performance with Edelbrock 8009 Throttle Cable Adapter Review

this is edelbrock what else can you say put that on a performance 600 cfm carburetor no problem if i had to buy it again buy the same but again this edelbrock they breed perfomance

I have not used it yet, but I know that I will in the near future. I like that everything you need to install is included. Saves you from chasing cotter pins and washers!

This is Edelbrock what more can I say put this on a Performance 600 CFM carb no problem if I had to buy it again buy the same one, but again, Edelbrock is like that, they breed performance

Thought it would be a 1/4" thread but it isn't. The threaded end is #10-32 [0.185" diameter] x 3/8" long. The plain end is .220" diameter x .275" long and provides a usable space between the washer and the shoulder of approximately .110" wide. The washer has an inside diameter of 0.265 x an outside diameter of 0.496 x a thickness of 0.030. The pin hole is 0.063 inch in diameter. The overall length of the cotter pin is 0.058" x 0.77". Should work well with most carburetor fasteners as long as…