Header banner
Revain logoHome Page
🌈 eryone 1.75mm rainbow filament for printers logo

🌈 ERYONE 1.75mm Rainbow Filament for Printers Review

3

·

Average

Revainrating 3 out of 5  
Rating 
3.0
🖨️ 3D Printing Supplies, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to 🌈 ERYONE 1.75mm Rainbow Filament for Printers
img 2 attached to 🌈 ERYONE 1.75mm Rainbow Filament for Printers
img 3 attached to 🌈 ERYONE 1.75mm Rainbow Filament for Printers
img 4 attached to 🌈 ERYONE 1.75mm Rainbow Filament for Printers

Description of 🌈 ERYONE 1.75mm Rainbow Filament for Printers

1.Multiple colors, like rainbow. 330 meters long and 20 colors. 10-meter filament in one color and 10 colors in a cycle: Purple - red copper - green - sand yellow - purple blue - ice blue - bronze - orange - rose red- light purple. 2.Print Temperature Range & Diameter: 190-210¡æ. 1.75mm (tolerance ¡À0.03mm). 3.High Quality: No bubble or dust inside, neatly rolled to reduce clog or tangling. 4.Sealed vacuum bag to keep it dry and keep out dust. 5. N.W: 1kg, G.W: 1.35kg, spool inner diameter 57mm, spool outer diameter 200mm, height 64mm.

Reviews

Global ratings 3
  • 5
    0
  • 4
    1
  • 3
    1
  • 2
    1
  • 1
    0

Type of review

Revainrating 2 out of 5

Uneven thickness. Clogged extruder on E3 V2.

I really liked the colors and the 2 prints I was able to get from this roll of rainbow silk were good. The problem I had was that about ¼ of the way through the roller it started scraping off bits of filament in the extruder. It eventually got clogged, the filament chewed up, and stopped printing 10 hours after 24 hours. I figured maybe something else might have gone wrong and I cleaned everything up, then cut about 6ft off the spool and started again with the fine print. The same started to…

Pros
  • 3D printing filament
Cons
  • Some bugs

Revainrating 3 out of 5

The thread is excellent but the colors are not impressive.

I have a lot of experience with Eryone filament printability and it has not caused any printing problems. I give it top marks for its printing properties. However, the rainbow color is not what I need. The colors are a bit dull, I wish they were stronger. Depending on what you're printing, it also requires a large amount of filament to change color. If you're printing small items that don't use a lot of filament, you won't see big color changes. For example, I printed a model of a hairy lion…

Pros
  • 3D printing consumables
Cons
  • Very expensive

Revainrating 4 out of 5

A very impressive metallic iridescent silk PLA with some caveats.

In summary this is a very nice silky iridescent PLA coverall. However, there are reasons to lower the rating by one star and I will explain them below. I'll start by listing the things I liked about this thread: - Excellent winding. That's not always the case with Filament (even with Eryone), but this reel wound well - both in terms of tension and accuracy. - Printing was easy with this filament. I used 208 degrees (230 first layer) and it printed exceptionally well (no bad prints). This seems…

Pros
  • Industrial & Scientific
Cons
  • Crumpled