🚗 ESUPPORT 19mm 12V 5A Car Green LED Light Angel Eye Metal Push Button Toggle Switch Socket Plug Latching – Black Shell Review

Great switch. Smooth lines and very flat after installation. The only thing I don't like is that I wish there was a way to not turn on the LED. Also perfect!

Well tested, installed and running with LED panel and it started smoking. All of my fears were correct, along with the right fuses and relays. Not worth the price and fire hazard

Let me preface that I haven't used them but they were well packaged. They feel durable and look well built. I'll update my review after I've completed my project and I can test it properly.

Wiring To make the switch light ring light up when the switch is pressed and not light up when not pressed, I connected red to green, then connected to the positive side of the load, black to the negative ground, blue to the positive 12 volt source. Yellow closed. I hope it helps.

Negative. There are no instructions and the circuit isn't exactly the same as the switch but close enough to understand. positive moment. This switch looks and feels big! The color is dark red and it matches perfectly with my red LED headlights that I hardwired to the car.

I've tried different versions of this switch and this is my favorite. The ones with the wire harness are very difficult to connect because the terminals are tiny. I now have three of these on my daughter's Power Wheels car to control LED lights and a volt meter.

Overall I like the fact that I am using this trip relay to start the AC compressor on my old truck. When I ordered I was concerned that it might be too bright when driving at night and it's a bit brighter than I need. I'm sure a PWM dimmer could be added but haven't looked into it yet. I'm glad I have air conditioning and now the wife doesn't persuade me to switch to a new truck.

The switch appears to be fine, but it is not printing. Had to read a consumer question/answer here. Basically, my biggest complaint about this derailleur is that you can't see the back of the derailleur. with pens will test your patience. The plug is bigger than the switch, so it doesn't look like you can plug it in first by sticking it in the hole you made. keyway?

Here are some instructions I used to hook up the auxiliary connector to my Polaris Ranger's bed. Since it is only rated for 5A I decided to connect this switch to a relay. That way I was able to hook up a 20A aux to my bed next to it. If 5 amps suit you then you don't need a relay. Instead, just connect what I call the + signal to your load and run a wire from the negative load post back to your battery or chassis ground. Use the Always On setting if you want the light to be on all the time…