ESUPPORT Car Marine Red LED Toggle Switch Dash 4pin Pack of 5 - Illuminate Your Vehicle's Controls with Style Review

The switches worked perfectly. If you look at the back of the switch with the two unused pin headers facing up, the pins on the left are for the power and the pins on the right are the test light bases. . The upper left pin is the line or power input, the lower left pin is the line out to the device controlled by the switch. The test lamp is powered from the top left pin, and the top right pin is a non-switchable ground for the test lamp. and when grounded, the test lamp is always on when the…

As others have pointed out, there is no LED here, just an incandescent bulb. I measured the current and it draws about 50mA compared to 20mA typical for an LED. It didn't hit the battery as hard as I feared and it's nice that it's not polarity sensitive, but it's still a big problem for a seller to lie in a product description. The switch side is marked SOKEN RK1-08. 16A 250V AC and no other ratings. Should I entrust him with 20A DC? For live ones this may be fine, but for interrupts DC is more

As far as I can tell this is the best price for this type of toggle switch. I installed them on my 04 Wrangler, in the car's built-in rocker switch tray. This required some modifications as these switches are not really designed to fit into the pre-made rocker slots in the TJ model. However, they work, you just need to change the slots in the machine. I had to cut them off a bit at the top to make room - these switches are larger than the switches TJ designed. However, they work well. The…

I lowered my initial rating. As I started working with them more I have two main problems: 1. They are not LED and the bulbs burn out very often. Revain needs to remove any mention that these are LEDs as this is a misleading description (as pointed out by other reviewers) and totally false advertising.2. They are not suitable for the marine environment, especially if you swim in salt water. On my boat they are well protected from splashes etc., but only lasted a few weeks. Each switch…

Good price. Functional. The switches arrived in a clear plastic bag with no instructions or pinout information. These are 20A 12 volt stings commonly used in cars, boats and outdoor recreational vehicles. They use standard size crimp spade connectors. These can be bare connectors as spade connectors have molded plastic shielding walls that separate/separate between each blade. When viewed from the rear, there are four (4) standard size flat blades (plugs). Connectors on the back of the switch…