🚀 Revolutionize Your 3D Printing with Filabot TB1 Taulman Bridge Filament Review

When the filament prints right, it prints great. I had high expectations for this thread. However, the roll I received was of terrible quality. The diameter ranged from 1.82mm clear to 1.48mm. In the areas where it was 1.48mm, it wasn't pushed out completely because the drive couldn't come into contact with it. So when I made a very small print and the filament landed in a good portion of the spool, it worked great. But the "good" sections of filament were only 1-2 meters long, so every print…

I made several prints with this filament on the Ultimaker 2 and got great results. This material is extremely strong and flexible. The material itself is much stronger than ABS and adheres to itself better than ABS or PLA when printing. I haven't had any issues with it in terms of material quality or printability. Whatever you print will most likely be flexible unless you make it really thick. So far the items I've printed have been 2mm thin and 100% filled, things like phone cases seem to be…

Let me start by saying that this is a tough material! I've used this filament a number of times when I needed a durable print that could withstand some abuse. Very impressed with the durability aspect. Typing can be difficult, but if you use the right settings, you'll be fine. Here's what worked for me: 1. Make sure the filament is DRY before you start. When not in use, store in a container or bag with desiccant.2. I have used a nozzle temperature of 250-260°C with great success.3. 45-70C on a…