🖨️ Fused Materials Black Printer Filament: Superior Quality for Sharp Monochrome Prints Review

NO Z SPACING REQUIRED! It's magic that I found it now. I had a lot of trouble with this until I discovered that by default, Cura creates a z-distance between the support material and the build material, even if the support is water soluble. I have a confusing mess with the default Z-distance (which only appears when showing expert settings). With a Z spacing of 0 and a support roof, my prints come out nice and clean. I would also recommend using a primer tower which removes the liquid from the…

I have several printers on which I print on different materials: PLA, PETG, ABS, PC, PC-CF. Whenever I switched from high temp to low temp material I had (understandably) inconsistent extrusion and no clogging. I thought I would try this one. It works. Maintains similar extrusion properties from 190°C to 270°C. When I change filament type I run about a foot or so through the hot end at about 15-20C above the temperature of the last filament I ran. Pull out, skip the next thread until you get…

**Update cause below** There was an issue that persisted after printing for at least a few hours after the filament clogged. I don't know exactly where the problem started, but after "unblocking" the clog with the nozzle wire, the clog re-blocked after only about 10-30mm of thread. I changed the nozzle, changed the filament (several times) and even switched to a dual gear extruder, nothing worked. I pushed (using touch menu extrusion) about 200mm of this cleaning filament through the nozzle…