💪 Enhance Efficiency and Power with the Gates AX39 Tri-Power Belt Review

Very good belt. The gear design helped solve the wear issue I had with the supercharger. The supercharger motor had a small diameter pulley and the belt had to be guided around this sharp bend. I changed belts every six months until I started using the serrated version. Two years is still good!

I used this on my Craftsman table saw because other belts seemed to have a misalignment problem. This happens when you don't use your table saw for several months, causing the motor and belt to jump up and down, making it difficult to cut through a thick piece of wood. I bought this belt and two TB Woods AK2558 pulleys to replace the original cast pulleys and the table saw runs smoother. And since it's a Gates belt, it will last a long time before needing replacement.

This belt is used on the Craftsman Table Saw. It replaced a badly worn original timing belt. This is a much more flexible belt than the original V-belt. I tried replacing the belt with the original type and I had severe vibration when running and shaking when starting and shutting down. The timing belt all but eliminated this, resulting in a much quieter and smoother saw. I think this is a better solution than a pivoted belt as rapid wear seems to be an issue with pivoted belts. Timing belts…