🖥️ GeeekPi Raspberry Pi 4 Metal Case with Fan and Low-Profile CPU Cooler, Enhanced Raspberry Pi 4B Case with Horizontal ICE Tower Cooler (Silver) Review

Advantages:1. Aesthetically attractive 2. Keeps Pi4 super cool and secure3. Made from high quality materials4. Comes with an acrylic stand for standalone use. Cons: 1. Installation is more difficult compared to other Pi42 cases. It is impossible to replace the SD card without removing the upper case, which consists of 8 small screws.3. No access to GPIO without removing the top case.4. That's expensive for a Pi4 case. I don't understand why they included an acrylic stand as the RPi4 will not…

These are really two different products. You seem to be the first time in this combination product. The fan is good. During the stress test, the Pi4 ran at 2 GHz and the temperature never exceeded 50 °C. It has been in the 46-48C range for a long time. Without a cover, the temperature is about 3-4 °C lower. In idle time the temperature inside the case is 34-37C. I would buy a fan if I had to do it again. The case appears to have been designed by a Chinese basket maker (get it? basket!). The…

There are a lot of bad reviews about how difficult it is to assemble. It may be confusing, but it's actually very simple! I recommend anyone who buys to watch a youtube video on assembly (I found at least 2, they exist). The tightening of the screws is because the body is aluminum. When one is unscrewed, the tension shifts. Same as reassemble. I would recommend loosening all the screws. before completely removing one of them during disassembly, and then running all of them before tightening any

I really don't like leaving negative reviews. Unfortunately, I cannot recommend this case to anyone. First of all the fan is absolutely amazing and I really enjoyed just using it on the clear riser when setting up my Pi. The problems started when I took it apart and returned to the aluminum body. First, I didn't have a thermal tape. Good. Luckily I had my own backup. Then one of the screws holding the Pi to the case broke off in the aluminum standoff. Not only did this leave me with a piece of…

The seller selling this is not a 52pi manufacturer so I won't attack him too harshly. This review was written by a customer who wants to buy this case. Pros: Comes with a spare fan. There are extra bolts, risers, washers. if you buy it in bulk on aliexpress in China. Cons: - Cheap fan/heatsink feel - Thermal strips are smaller than Raspberry Pi processors, I think a bit more would be better. - Requires 8 screws to screw the cover on, I find it a bit redundant. Especially when you come in and…

I give 5 out of 5. I have to say the instructions are not clear but I wasn't expecting much, this is a very cheap part from China. You must place the cooler on the Pi BEFORE assembly to ensure you have your hands on the correct sides. When you are ready to assemble you will need to attach two studs with nuts to the I/O side of the Pi, there are no threaded tabs on the case for that side and the I/O components hold it up. Then use bobby pins to secure the other side, it's a pain. Insert and…