💪 Enhanced Performance: Genuine Bondtech BMG Extruder EXT BMG – Unleash Precision and Reliability! Review

Original BMG in excellent quality and works great. I use it in a direct drive setup on my Ender 5 with a Micro Swiss clone hotend. I bought it months in advance to replace a bmg clone that wasn't working properly and I didn't want to change my printhead configuration. Turns out something else in the setup was the problem and the clone is still fine. I'm using clones on an Ender 3 printer to this day and I have to say clones are way better, especially on cheap printers like the ones I have. The…

The standard cheap extruders that came with my FlyingBear Tornado 2 had trouble pushing/pulling filament through 800mm Bowden tubes, even after replacing the standard tubes with very good Capricorn tubes. After reviewing various options, I settled on Bondtech. I wanted a ready-made solution that was tested. Many people seem to have had good luck with cloning, but some have not. As with any extruder replacement, DO NOT wait for a replacement without a replacement. I had to solve 2 questions.1…

I have three Anycubic Mega X printers and they are all great. except for the absolute garbage extruders that come with them. Literally all three printers went down within a month because the extruders were unreliable and couldn't print for more than 20-40 minutes without slipping or complete filament failure. I was ready to convert them to direct drive or just toss them in the trash until I noticed someone mentioning that they had just replaced the factory extruder with this Bondtech and it had