🔥 Genuine E3D Socks Pack V6 SOCK PRO 3PACK - Ultimate Heat Protection for Your 3D Printer's Nozzle Review

I print mostly PETG and the sock prevents most stuck nozzles from leaving burn marks or unwanted hard parts on my prints. But there are problems with these socks: 1. They don't hold the heat block well. Because they're cast in block form and don't have a locking mechanism, they don't snap as if they weren't as flexible. The little protrusions at the top just don't hold it, so there's always some flexibility there.2. Due to the fit, the bottom may sag slightly, creating a gap between the heating

These "Pro" socks are almost identical to the original silicone socks except they cover the nozzle down to the smallest part of the tip. They also completely cover the bottom screw hole of the heater block. They help prevent winding and melting of the filament on the outside of the nozzle. They also help maintain the appearance of the heater block and nozzle. They also retain a bit of heat at the block and nozzle, making it a little easier for your electronics to keep the hot end stable…

Anyone who prints from PETG probably knows that PETG likes to get stuck on the hot end. Even if you don't have setbacks, PETG will still find a way. Due to some research on the internet I found these and decided to give it a try. The first caveat is that they don't always hold up well, even on a real E3D hot end. I just don't think the top of the silicone doesn't have enough lip and it's very flexible and you apply it to the hot end which runs at around 250C. The first sock I used kept leaning…