💧 Govee WiFi Water Sensor 2 Pack - Adjustable 100dB Alarm & App Alerts, Leak and Drip Detection with Email Notifications - Ideal for Home, Bedrooms, Basements, Kitchens, Bathrooms, Laundry (5G WiFi Not Supported) Review

The battery indicator shows 100% when the batteries are disconnected! Support had a voicemail box and called back a few hours later. Didn't have a way to check if the battery indicator was working, so I did it myself. When the batteries are 50-70% charged, the battery indicator in the application will show a full charge. The sensor started beeping until the battery died. No low battery alerts were sent. Don't buy this! You'll never be sure the sensor is getting power until you pull out the…

This is exactly what I was looking for. This allows me to track down possible water leaks in the basement, especially near the HVAC unit. Last time, the drain pipe was slightly clogged and some of the water didn't drain properly. Not much damage, but enough to damage some of the carpet in the area. Not much damage though. I was able to replace and clean everything for less than $500. Now I have two such sensors next to it. I have tested them and so far they are good. I hope they don't let me…

Initially I tried many iterations of connecting the gateway to my router via the Govee Home app. I watched the video and carefully followed the written instructions. It wasn't until I restarted my iPhone that I was successful. I think restarting the phone should be a mandatory part of the process. I think the videos and written instructions are a bit lacking. The sensors work well and generate drip and standing water alerts, but I turned the beeper off (would that save battery power?) because I

I received the unit and read the installation guide a few times and then proceeded with the process. Everything was working fine until it was time for the gateway to connect to my router. I've tried to connect it over 15 times and it refuses. I have read and re-read the instructions in case I missed something. I moved the device within 10 inches of my router. I disabled 5G on my router and rebooted several times. All for free. I finally gave up and sent a message to tech support asking for…

Easy setup. I poured some water on the sensor and got a notification. HAPPY ! .After one week, the hub (gateway) flashes blue quickly. I go to the app and it says my sensors are disabled. The gateway is 6 feet from the router. Yes, I could probably start over and set everything up again, but if the water sensor is unreliable, what's the point of having it. Planned to use it when traveling. I will come back for the same article. Hopefully 2 times is a spell. I will add. Update: With the 5GHz…