📦 Homydom 3-Level Lumber Storage Organizer Review

I like these, despite some reviews they came and were easy to put together and were straight and in line. The trick is to NOT fully seat the mounting screws on the levers. I screwed them in 3/4 and my hands were fine. I loaded each shelf to the maximum because I have a lot of firewood. They hung on my garage wall for over a month with no problems and it was a lot easier to find the right wood for the project. However, I did not use the included wall screws based on reviews. I used high quality…

In general everything would be very good if it weren't for some quality control issues.1. Holes in several pins were not drilled through.2. One of the arm mounts wasn't welded straight and couldn't be assembled. I was able to drill through the pins fairly easily with a drill press. A crooked mount on one of the arms was the bigger issue. I couldn't even get the pin through the hole. I used a rat tail file to open up the holes until I managed to get the pin in and the arm was sitting straight. I

It was easy to install but you have to be sure to find the center of the shelves. They're easy to miss or just hit the edge of the post, so take your time to make sure you center the supports on the post. Another thing is that quality control needs work. Support and suspenders were ok. Quality problems relate to other parts (pins, screws, etc.). In my case, one of the steel dowels didn't have a pin hole on the end. (I've seen similar comments from other customers about parts.) It only took a…

Large shelf for wood. Includes true 3" lag bolts. This set is cheaper than another from kastforce and more customizable where the support beams go. More importantly, the support beams are adjustable to a degree and can be raised, held in place by a pin. I don't expect to have to raise the bars vertically, but it's fine if needed. Also, the logs are a few inches longer than the Kastforce, meaning more wood can be stacked on top. And it's cheaper than other comparable ones! Cons: no instructions.

(-) The first two screws I tried broke (broken). Both bolts broke in the same place - where the thread starts. I pre-drilled the holes, no problem. I switched to my own screws and no more problems. The fittings that come with the shelves are of poor quality (+) The overall design is good; easy to install and set up. The quality of the stands is pretty good. I'm curious how the coating will hold up over time. They seem strong enough for most uses. Good for finishing and smaller wood. (-) A…

As mentioned in many of the comments, in order for the racks to reliably support the weight that these racks can support, you need to buy screws. I bought 3" 5/16 anchor bolts for 52 cents each from Ace Hardware. Get 4 anchor bolts per pack (I bought 8 for my 2 pack for example). Installation Notes 1. I found the studs about 48 inches apart. line (6' level) where the bottom of the supports should be 3. Mark a vertical line (2' level) 16" above the bottom mark 4. Mark and drill a pilot hole for…