🔌 iJDMTOY 10-Second Time Delay Relay Module: 5-Pin 12V 30A SPDT for Automotive Lighting Review

It's not universal and why can't I find a suitable one for my truck? Too busy selling junk. It won't fit the 2004 F250 so don't buy this junk if that's what you want!

Works as advertised, used with HID suspension on a 2009 Goldwing. Helps my battery on start-up as the low beams come on after ten seconds instead of when the ignition is switched on, reducing battery drain. Many Thanks.

Didn't work at all. Plugged into a working relay socket and nothing happened (waited 3-4 minutes and still nothing), replace with a normal 5 pin and the light will work as it should again. Not sure if it was just a bad block or if they were misadvertised. Got my money back through Amazon with no problems.

I was hesitant to buy this due to a previous one star review. I also seem to have the short end of the stick and the relay doesn't work at all. I measured the resistance between 86 and 85 and got a value higher than 120 kΩ, it should be between 60 and 120. Doesn't matter. blocking doesn't work at all.

Doesn't fix flickering lights but fixes the error messages you get. It just fixed the error message I kept getting, which was helpful. But I realized that I really need to buy an LED conversion strip for my wiring to get the LEDs to work.

This relay helped me. I wanted to prevent my Kenwood D710 from turning off and on again when I first start the car and this relay helped. Even with my radio connected directly to the battery, my Toyota's battery is small enough to have enough voltage drop at startup to cycle the radio off and on again. With this relay connected to the ignition switch circuit, when I push the start button the car starts and after a delay my radio turns on with clean 12V DC. Good.

I installed them on my Dodge Ram 05. I switched my headlights to projector bulbs with HID bulbs. I have to leave the headlights on for the parking attendants because they don't know I have a separate headlight switch and it's bad for them if the HID flickers on startup. It was the perfect solution, the truck started and within 10 seconds the HID turned on, no more power surges. It fitted into a standard relay connector and I had no problems. UPDATE: lasted ONE year. Now it just blinks like a…

I used this to delay the turn on of a secondary amplifier connected to the speaker outputs on a 2016 Subaru. The car sends a nasty loud bass through the stock speaker wiring when the car is first started. This works great for delaying turn on and solving my problem, but for some reason mine allows an instantaneous voltage drop of 6-7 volts until it switches to 12 volts at ten. seconds. So if you plan to use this for a stress sensitive element, this could pose a problem. As long as you need at…