Upgraded Inland 2 PLA Printer Filament - 85mm Review

I've never printed PLA+ at 225C or anything less and this thing clogs up right away and starts grinding in my extruder or periodically stops and sneezes into the hotend. I bought it specifically to match the color requirement and it doesn't even look like the pictures. To its credit, it doesn't sag or become brittle at such high temperatures, and the strength is really good. It's just a very strange experience that every other PLA+ I use prints with the same setting so easily. It's also rare to

I love the color of this yarn and I was planning to use it to make some bone like Halloween prints but damn this yarn made me sad, when it came to calibration. I usually run many calibration prints for each new filament, e.g. B. for the flow cube, the temperature tower and the retreat tower. I've never had major problems when it comes to sizing new threads, but no matter what I did with this thread, I couldn't get it to stretch like crazy. Tries to lower and raise the temperature. I've also…

Very Frustrating! I'd love to say I love this thread, but the way they wind the thread onto the spool makes me keep an eye on the pressure every time. Right from the start I can hear the spool moving as the line is pulled down. You can hear the thread getting tangled and after a while it finally loosens and untangles. On two of my prints there have been instances where the thread has become tangled but has not been able to disengage quickly enough and the thread has snapped. Luckily, every time