🏍️ Enhance Your Harley Dyna Fatboy Softail V-Rod with Jade Onlines Universal Gloss Lower Chin Fairing Front Spoiler - Ideal for Touring Glide Review

Definitely doesn't fit my '09 Softail Deluxe. I doubt it will fit any legacy or anyone with an FL front fender. Might have worked for the fat man and smaller wings. I had to cut half and redo it by moving the tension regulator. To get at least half to get my wing through. No instructions. Likely to fit other models with smaller front fenders.

Well you can pay $250 from HD and get the shield emblem on a molded piece of plastic. or $32.99 from Revain 🤷‍♂️The front chin spoiler (aka "bike beard") was easy to install. Came with all accessories and instructions. All you need is some LockTite. My only complaint is that the included bottom mounting screws weren't black, but they're unlikely to ever be seen. Will probably get me enough to replace them anyway 😆

I like this article. Very good on my 2018 Harley 48. I will say be careful and pay close attention to the gear. Mounting bolts climbed into the frame with difficulty. This also applies to Harleys and the way they paint frames. It is necessary to play with the bolts, tighten a little, then loosen, then tighten again, the thread in the motorcycle frame is broken. Maybe spray the big bolts with WD40 which I did and it worked. You still have to be careful when dressing.

Very easy to install with a visit to the hardware store. The two bolts that go up into the frame fit perfectly, as do the two smaller screws at the bottom. Inside the spoiler there are 3 screws holding the bracket, 1 is threaded the other 2 are not. I used a screw that was snug against the elbow and that fixed the problem. It gives the bike a clean look, not a single scratch on it as my biggest fear was that they packaged it well so it wouldn't get scratched in shipping.

What a hassle to install. The tab on the bracket that bolts to the frame wasn't bent at right angles, nor was the tab on the small bracket that bolts to the plastic spoiler, which required gentle persuasion. Also, the holes in the small bracket weren't big enough for the big black plastic screws, so more had to be drilled. The small silver plastic screws fit but weren't long enough to attach properly. Getting the bolt through the hole in the floor was a challenge (especially solo), but with…