🔧 K Tool International KTI KTI 70550 Sanding: Professional-Grade Sanding Solution for Precision Results Review

Worked but is only good for SMALL jobs. The pen length is deceptive. The actual abrasive product is just over an inch long. I bought it to clean decorative carvings from wooden furniture during renovations. It worked great, but was used up within minutes. It is too expensive and short-lived for such work. If the grinding insert was the entire length of the pen, everything would be fine.

I bought a used 2016 Mustang that someone before me seems to have spent quite a bit of time on the freeway as there were a dozen chips in the bumper. (very small but noticeable as the car is white and the chips appear black). The grinding pen made it very easy to clean up all the wounds and prepare them well for painting without damaging the surrounding areas and making the touch-up more visible. Would definitely buy another one of these if I need to do more touch up work. Yes, the fibers are…

Glad I found this product. It is basically a dense bundle of glass filaments. The open end of this bundle cleans corrosion like nothing else. I've used it to clean electrical contacts, battery terminals and rusty dents on my car. The design allows it to get into corners, grooves, etc. that sandpaper would miss. Quickly removes rust.1: Use outdoors. Small glass splinters come loose during use. 2: Do not hand brush the repair area unless you like prickly pear thorns in your skin. 3: Protect your…

The handle does its job well but the tip size is too big for grinding gravel on a car. . If a coin sized pebble gets into your car that's ok and leaves a pea sized chip then it can be used. I'm not sure why so many auto paint part manufacturers fail to realize that most chips are much smaller than the products they make. I understand this is a generic tool but automotive engineering was in the description so I'm getting a little breathless after looking at this and touch up paint kits that have

I bought this to clean some dents in my car's front grille. I'm driving a low ride Miate and someone got behind my front end and left a few swollen nicks that deformed the clear coat and primer. Think about what a broken cone looks like. I had to sand down two symmetrical spots the size of a coin before adjusting the color. This pen was perfect for the job as the fiberglass bristles snap off allowing you to make more strokes without feeling like you're damaging an existing surface. It took…