KFI 🏞️ Products Winches 100630, Regular Review

The block width is about 3/8" wider than the frame width of my '95 Big Boss. I need to add extra spacers. Otherwise it's a good lift.

Easy install, good fit for my 93 Polaris athlete. Good build quality and many winch mounting options. Also had a 2 hole jig and winch plate.

This plate is well made, easy to install and as other reviews have said I took the advice and used 1/4 inch longer screws! Excellent quality and durability! Thank you Kelly.Z

It was easy to install. A word of caution though. You may need to put a washer under the winch to move the winch motor sideways. This is required to center the cable for use with a plow.

For 1994 Polaris Sportsman 400. It was fairly easy to install. The bolts are a bit short, but if you use a clamp to squeeze the sides of this winch mount you should be good and easy.

When I bought my ATV the existing winch was attached to a plate welded to the push rod, functional but barely noticeable. Not only was this mount perfect for my quad, it was also easy to attach. Comes with everything you need and the extra winch mounting holes allowed me to fit a block and pulley winch hook. I found the 2 bolts to be too short, but I think it was an issue with my rig's push rod, not the bracket or hardware. When you're standing on a fence with this mount, jump down, command it,

Try winching on a 1995 Polaris 425 Magnum! Too bad we don't have this set! The design is correct, it took a while to install on a 4 wheeler but it works great and will last for years! The studs seem to be too short until you play with the mount. I've found that tightening all the hardware at once and waiting for everything to tighten makes installation much easier. --- Pros --- Excellent quality -- Easy installation -- Works with almost any winch - Looks like a factory part --- Cons ---- Must…

Overall the mount is of good quality and looks pretty solid (haven't tested it yet). However, a few problems arose. First, the installation instructions were a bit fuzzy on where and how to install the washers. Second, I thought the screws that came with were too short, so I bought longer ones at my local hardware store. Thirdly, in terms of design, I'm not sure how this mount connects to the wheel is the most reliable solution. I feel like hanging by the brush guard means trusting the brush…