🛡️ Lincoln Electric - KH495 - Durable Canvas Cover for Enhanced Protection Review

Does not fit the power cord and argon line hook on the back of the welder. They must be removed to allow the cover to be placed on the welder.

I wasn't sure about the size as it's cheaper than what specifically says it fits my welder. I have a 180HD welder sold by Home Depot. This case seems to be specially designed for him.

A little pricey for the price - the fabric feels a little thin for the price. But it saved me by making something to order. I used this on my Lincoln 180C and it fitted well.

later when using this to cover my Lincoln Squarewave Tig 200. I turned it back so the slot would slide over the gas line that goes to the back of the machine. I had to trim the gap a bit but it works fine. The material seems a bit cheap but I think it will do the job.

Fits my 140HD well and keeps it dust free. I live on the corner of two dirt roads and my garage is always open, so I dust everything all the time. This has kept my welder looking like new for a few months. The cutout is good, wish there was one in the back for the gas hose, but it still fits well.

Fits and looks good. was expecting something heavier, more water resistant or just better to justify the price. Don't get me wrong, there's nothing WRONG about it, but for $30 I expected it to be WOW, but it was ok and IMO quite expensive for what it is. I'm keeping it and glad my welder is covered but I think it should have been 2x better or half the price

Pocket for flashlight handle. There's no gas cut-off on the back, but it's not needed. The cap fits over the fuel line on my 180T. I use SP-100 for the flux core so no gas is needed. Since the gas port is at the top rear of the welders, I'd rather not cut out; If there was a gap going that far, the lid wouldn't fit snugly against the welder. The fabric is a medium weight canvas, strong enough for a welder's boot. It's like the stuff of a heavy painter's tarp. This is great for its purpose. As…

When I used this to cover my Lincoln Squarewave Tig 200. I turned it back so the slot would slide over the gas line that goes to the back of the machine. I had to trim the gap a bit but it works fine. The material seems a bit cheap but I think it will do the job.

Fits my 140HD well and keeps it dust free. I live on the corner of two dirt roads and my garage is always open, so I dust everything all the time. This has kept my welder looking like new for a few months. The cutout is good, wish there was one in the back for the gas hose, but it still fits well.

Cutout fits torch handle. There's no gas cut-off on the back, but it's not needed. The cap fits over the fuel line on my 180T. I use SP-100 for the flux core so no gas is needed. Since the gas port is up on the back of the welder, I'd rather not cut it out; If there was a gap going that far, the lid wouldn't fit snugly against the welder. The fabric is a medium weight canvas, strong enough for a welder's boot. It's like the fabric of a heavy painter's tarp. This is great for its purpose. As…