🔧 Enhance Greasing Efficiency with LockNLube 8-Piece Quick Connect Greasing Accessory Kit Review

I like it so far. The first connector I used was a 90 degree or right angle adapter. It won't work the first time. I had to disassemble and prepare, then everything is ok. All in all I think the set is worth the money.

The kit was pretty good for what it is. does what i need However quite expensive for most people. The fitting on the flexible hose that came with the kit got stuck so I replaced it with another one that got stuck, but other people have said this is likely to happen.

I use it every day for my work. It works mostly as advertised. I had to change the tip on the hose extension. I have found it impossible to remove or disassemble the grease fittings without a vise. The closure in the tip is too aggressive in my opinion. I use a Dewalt 20v grease gun. I just used a bearing tip which I removed when I installed the bridge and grease sleeve.

Processing and delivery went smoothly. The product is the best compound for lubricating anything with a grease nipple! No loss of lubrication due to poor connection with leaky mirror fittings. The Zerk fittings should not be pulled out as the pressure on the hose will not allow the end to disengage from the Zerk fitting. The fitting that is permanently attached to the end of the grease gun hose can be a bit longer in places, but the other attachments in this kit really fix any gap or reach…

This is a nice set of different grease gun tips that are hard for mirrors to reach. just. I've had other adapters that had some sort of sliding sleeve that could be slid over the tip to keep it straight and then slid up to allow it to loosen. I liked these better because they worked with any grease gun. They're good quality and work great if you already have a Lock-N-Lube tip, but I wouldn't choose a gun without them.

Kit foldable case leaves a lot to be desired. Getting most of the accessories out of the case isn't easy, especially after a few uses. And it turns your Lock & Lube clutch into our 8th standard Zerk clutch, taking advantage of buying a custom Lock & Lube clutch from you to use one of the accessories. The other end of every accessory they have has to be a mini version of their Lock & Lube so you don't end up with the same old Zerk installation problem.