High-Quality MakerBot PLA Filament: 1.75mm Diameter, Large Spool, Vibrant Blue Color Review

Does not stick to build plate or stick together. I couldn't even get through half of the printer before I had to drop it. Despite a two-week delay, I returned to my usual brand.

Works well. No problems, prints clean and fits my MakerBot printer perfectly. Suppose the plastic bags that these things come in should be chosen by the least intelligent person working at MakerBot. I say this because the delivery itself destroys the bag with constant bouncing and rubbing. The air seal is broken and moisture can damage the filament before you can even use it.

No desiccant pouch included so extrusion roughened by moisture. I slowly dried the coil in the oven at 60 degrees but it sat down, bent over and stuck to itself. I had to unwind the spool and then wind it back up. It also appears that the blue pigment increased post-print linear shrinkage by up to 8% when the part was heated above 70°C. Initial compression shrinkage was very good at 0.3%. No color next time and request a desiccant bag