🔧 Micro Swiss V6 1.75mm Nozzle for RepRap Review

Decided to replace brass when replacing parts after hot-end failure. Haven't made any abrasives with it yet, I'm sure there are other reviews on this. I was happy that I didn't have to adjust anything to get the same print quality and that I didn't have to reconfigure the multi-material filament changer.

Just make sure you install this attachment CORRECTLY, otherwise fully tighten the attachment to 250C, but no more than one finger on wrench. can tighten. Then you let it cool and then do it again to compensate for the weakening caused by the temperature change. This way you don't pollute the thread in your hotend :)

Humans, PLA and ABS print well with a brass nozzle. I changed them every kilo of thread I used. I spent extra money on this product and it was worth it. Wear is zero and the carbon fiber seal is great and doesn't clog. Now both of my printers have nozzles and my enjoyment of eating and printing regardless of the material has solved many problems.