Neiko 10184A Titanium Drill Speed: Enhance Your Drilling Efficiency! Review

Bought this for my husband who needed a 3/4" drill bit to go through 1/2" metal. He told me it was very sharp and went straight through. Metal"as if it were oil". He said the hallmark of a good sharp drill is that when it cuts through, it leaves the corkscrew looking like a continuous piece of metal. And it was great. he said he couldn't be happier.

I've used this on a few Jeep projects now and it always makes the job easier as you don't have to keep changing bits. I still use reamer for certain areas but it worked fine for a few holes in the body. I deducted one star because in several places along the fang seam the steps aren't big enough to go through, so the surface area of the hole is a bit too big.

I bought this drill bit to drill four holes in a 3/8 inch thick gate post and it worked great. I needed four 3/4" holes in a thick post for a driveway hinge. These are J hinges with 3/4" bolts going through the post. To drill the holes I put masking tape on the post and marked where the holes should go on each side. I then used a sharp point and a heavy hammer to make a small hole in the metal. All drilling was done with a Ryobi cordless drill, which I had to charge about halfway through. I…