Header banner
Revain logoHome Page
osidu carbide burr set woodworking logo

OSIDU Carbide Burr Set Woodworking Review

2

·

Very good

Revainrating 4 out of 5  
Rating 
4.0
🔩 Power Tool Parts & Accessories, 🔧 Power & Hand Tools

View on AmazonView on ЯM

Media

(4)
img 1 attached to OSIDU Carbide Burr Set Woodworking
img 2 attached to OSIDU Carbide Burr Set Woodworking
img 3 attached to OSIDU Carbide Burr Set Woodworking
img 4 attached to OSIDU Carbide Burr Set Woodworking

Description of OSIDU Carbide Burr Set Woodworking

10pcs Carbide Rotary Burr Set: Cutting edge diameter: 0.236'' (6mm), Shank dia: 3mm (0.118''), fits dremel tools and most small rotary tools. 【Usage】Suitable for grinding and carving materials such as wood; plastic; soft metal as aluminum. 【Durable】Machined from new raw tungsten carbide, hardness can reach to < HRC80, sharp and durable. 【Single cut 】Designed for rapid stock removal with minimum chip loading, prevent iron-chip accumulate and over-heat cause cutter head damage. Cutting burs are larger than normal ones which makes it easier to do the wood job, Larger cutters work quicker and bits of wood and wood chips will not get stuck,not burn the wood.

Reviews

Global ratings 2
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 5 out of 5

Excellent Bits for Woodworking

As a home improvement enthusiast, I always seek high-quality power tool parts and accessories .After trying out the OSIDU Carbide Burr Set on my woodworking projects, I can say that they did not disappoint. The set provides a wide range of bits with a long-lasting sharpness and smooth operation. They made carving detailed patterns on my wooden pieces a breeze. However, I noticed that the set's metal CASE was not very durable and prone to rust. Overall, I highly recommend these bits to anyone…

Pros
  • High-quality and durable carbide material ensures long-lasting use.
Cons
  • Some users have reported difficulty with the different burr shapes, which may require a learning curve to use effectively.

Revainrating 2 out of 5

Good for softwood, bad for hardwood

They don't match hard maple, the ends are finely trimmed but not on the sides, they don't even look sharp. I've tried speeds from 5000 to 35000 RPM and they don't cut the sides of hardwood well. On a soft piece of pine, they worked well. I wouldn't even try using them on a metal like aluminum, if they don't cut wood well I doubt they will work well. pine and other softwoods

Pros
  • Sleek design
Cons
  • Fairly good