🖨️ Enhance Your Creality Artillery Printer with Premium Pack of 3D Polycarbonate Accessories Review

Replaced the original wheels on my Ender 3 v2 and they are set very tight to keep them from wobbling. I started typing and immediately started screaming. I looked at the first few layers of the print to make sure everything was fine. Back to a white coating on the track and wheels. Like other reviews, this one isn't too difficult. I tightened it just enough to keep it from wobbling, but even with hand movements it feels too tight. I have purchased a couple of Creality branded discs and will be…

Given some of the negative reviews I think I was lucky because 12 of the 13 pulleys I received were perfect. The 13 was mostly good except for a very small scratch on the POM wheel. All pulleys turn very easily and the fit and finish of the POM and bearings is very good, I don't feel any play. They also contain an important spacer between the ball bearings. This spacer prevents the bearings from seizing when tightening the fasteners. In general a good buy.

Although the V-rails produce a slight "white" dust, the wheels seem to hold up much better than POMs that Creality has worked with on Ender3. These are not bags on stock bikes. I'm running at twice the typical Ender print speed and pushing the limits a little. The wheels hold their shape much better and I'll probably take them back as a regular consumable. The white dust comes from parts that are still worn and a small amount of polycarbonate chipping etc on the V-rails. There was also dust on…