Podoy Fuel Pump For Onan Cummins Generator 4KW Microlite MicroQuiet 4000 RV A029F889 E11007 12V Fuel Gas Pump - Part Number: 149-2311 Review

Great price. Half the price of others and works better than the original Onan Generator 4000. The original Onan only lasted 51 hours and cost three times as much. So if your onan only works 15 minutes for Ron and then stops working and you have to wait 5 minutes before it starts again, that's your problem with the fuel pump they installed in the garage. So replace it with one of these, do it yourself and save a ton of money. Because people who fix it will say everything else is wrong. Keep in…

It fits my Cummins Onan 4000 Microquiet Generator perfectly except the ground plug is too small for the bolt on the generator. I had to cut off their connector and solder on the connector from the old fuel pump. The installation was not difficult, if only because of the construction of the generator. Cummins left plenty of room at the back of the bay, but chose to place the fuel pump partially under the electronics module so anything needed to replace the fuel pump should come out. Poor design…

My problem was that my generator started and then stopped. The fuel pump was a possible cause so I changed it. But after doing some more work, I discovered that the problem was actually in my carburetor. After replacing the carburetor, the engine is heavily flooded. I checked the output pressure on this pump and found it to be around 6psi, which is way too much. It should be around 2 psi. I installed my original fuel pump and now the engine runs perfectly. When I found out about this, it was…

Numerous wiring and hoses (electrical and fuel) must be disconnected before the pump is 'opened up' to replace. Some of them are under the RV while others are accessible through the generator door. It takes some time. However, it was very disheartening to find that the seam inside the pump was leaking after installation. I discovered this the next day when fuel was piling up under the car. I'm not going to disassemble it in detail and reinstall the old failed pump - at least the old one has no…