Reprapper 201: Fast UV-Curing Standard Photopolymer Resin for LCD 3D Printing - Red Wax 1000G Review

Very brittle and very large elephant paws on the prints making them very difficult to remove from a plate even after a good soak in IPA. We used every setting of this resin and produced nothing but junk, lowered the setting (layers and exposure) to reduce first burn layers and traces, and still produced junk. After several attempts to run the small parts of the model at 1:87 and 1:64 scale and get ZERO usable parts, we threw away what little was left and went back to Anycubic resin. With…

As a newbie to the 3D community, I wanted to find a cheap resin to practice with. So far I have only used two other resins. I definitely like their packaging instead of plastic bottles. One of my bottles leaked while traveling. At first glance, it's not as thick as others I've used and had more bubbles on its surface. But after printing with it, the results were good. Also, it doesn't smell as bad as other resins I've used. It definitely works well and is worth stopping by to see if anyone…

The preview shown in the picture was printed with a 2s layer exposure, but I printed with this resin with an exposure of only 1.2s, at 1.2 it has a higher print quality, Apply PTFE on the FEP at 1.2 with exposure when I bought it was really cheap $12 now it's more expensive and now there are better options at $17 for 500g print quality. The smell is not that strong. If it gets on your skin, wash it off immediately, this resin is quick to irritate the skin. Color pearly white or white sand. But…