🌪️ CraftBot by Resistant MakerBot: Tornado Series - Enhancing Additive Manufacturing Products Review

A larger nozzle is great for large prints like PETG and ABS. No loss of detail when printing with normal layer height. Higher layer heights result in larger prints being printed faster while retaining more than enough detail. Be sure to pair this with a Micro Swiss all metal hot end for best results.

Used with my Creality CR-6 SE. Level the bed with the nozzle installed. With the right Z offset, I've had constant problems with prints not sticking to the bed. When you lower the nozzle, it breaks and rolls over the PLA sphere. I raised the nozzle and obviously the grip deteriorated. I tried several dozen prints and didn't get past the skirt without problems. About half the time the PLA stuck to the side of the nozzle and knocked part of the skirt off track. The diameter of the Micro Swiss was

There may have been a quality control issue with the one I ordered, but mine was significantly longer (nearly half an inch) than my other tips of the same design and form factor. I ended up having to measure out a piece of filament, carefully melt the tip and attach it to my bl touch to allow the probe to pass the tip of the nozzle. Once cared for, the prints come out beautifully. Just a big problem when I want to switch attachments. Between fumbling with a piece of filament and drastically…