Header banner
Revain logoHome Page
premium silk white pla filament 1 logo

Premium Silk White PLA Filament 1 Review

3

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🖨️ 3D Printing Supplies, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to Premium Silk White PLA Filament 1
img 2 attached to Premium Silk White PLA Filament 1
img 3 attached to Premium Silk White PLA Filament 1
img 4 attached to Premium Silk White PLA Filament 1

Description of Premium Silk White PLA Filament 1

Highlight silk pla filament Pearl White. No polishing needed printing at a high detail results in a beautiful finish. Industrial & Scientific › Additive Manufacturing Products › 3D Printing Supplies › 3D Printing Filament. Printing Tips: Recommend Heat Bed 50-60°C, Recommend Printing Temperature: 195-220°C, To Avoid being Tangled, Insert Filament into Spool Holes to Fix after Every Time Use.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Lowest Temperature (190°C) = More Shine

LOWEST TEMPERATURE = MORE SHINE. Printing up to 230°C. After a heater failure I happened to find that if you raise the temperature it turns dull gray. You want to print at the lowest print temperature for the shiniest silver. (See photo) Please note that I did not measure the temperature at the nozzle with a multimeter, so it may differ slightly for your installation. Also, unlike other PLAs, this material is very sticky (will shrink on its own) so a bed temperature of 40°C wasn't enough, but…

Pros
  • Industrial & Scientific Products › Additive Manufacturing Products › 3D Printing Consumables › 3D Printing Filament
Cons
  • No Instructions

Revainrating 5 out of 5

Good thread once you get the hang of it.

The thread was well packaged and the vacuum bag also has a zipper. Inside the bag was a desiccant bag. The coil was well wound and dry. This is a yarn with a very high pearlescence. My experience with such threads shows that they are softer but very smooth. You are really struggling with your extruder. They stick or slide. If they slip, they easily wear out where the extruder bites and cause jams. Because of this I have found that higher extruder temperatures produce less viscous flow and less…

Pros
  • Printing Tips: 50-60℃ Heated Bed Recommended, Recommended Printing Temperature: 195-220℃ To avoid tangling, insert the filament into the spool holes after each use to fix it.
Cons
  • No power

Revainrating 3 out of 5

Aesthetics I want to print with confidence and use with confidence!

I bought this thread after reading previous reviews so I knew I was probably in for a wild ride. As you would expect, the thread was packaged in a hard, resealable plastic bag. At first glance, there was nothing wrong with that. The thread looked similar to other "silk threads" I've used in the past, although it felt "light". It's hard to explain, but I'm used to a very hard thread and somehow it felt easier. The original purpose of this thread was to reproduce the golden angel for the customer

Pros
  • Polishing not required. The highly detailed print provides a beautiful finish.
Cons
  • boring packaging