Header banner
Revain logoHome Page
sunhokey filament detection – ensure seamless printing with reliable filament monitoring (pack) logo

Sunhokey Filament Detection – Ensure Seamless Printing with Reliable Filament Monitoring (Pack) Review

3

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🖨️ 3D Printing Supplies, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to Sunhokey Filament Detection – Ensure Seamless Printing with Reliable Filament Monitoring (Pack)
img 2 attached to Sunhokey Filament Detection – Ensure Seamless Printing with Reliable Filament Monitoring (Pack)
img 3 attached to Sunhokey Filament Detection – Ensure Seamless Printing with Reliable Filament Monitoring (Pack)
img 4 attached to Sunhokey Filament Detection – Ensure Seamless Printing with Reliable Filament Monitoring (Pack)

Description of Sunhokey Filament Detection – Ensure Seamless Printing with Reliable Filament Monitoring (Pack)

Filament Detection Module - Newly designed smart module, The main board executes the pause command operation when the filament is run out. Main Function -for checking the filament is whether run out or not, it automatically stops the 3D Printer when the filament runs out. Extended Product Life - A wear-resistant copper sleeve is added to the feed port and the discharge port at the same time can effectively prolong the service life of the product. 3D Printer Accessories-Very practical filament detection sensor module, ideal accessories for 3D printer, making your printing work smooth and relieved.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Check the contacts first

Both work as they should. I recommend checking the pins depending on which board you are using. There are 3 pens. A common ground, a 5V for LED and signal pin. i switched a signal and 5v to my scr 1.3. Easy swapping of pins in a simple plug and it works great.

Pros
  • Great for me
Cons
  • No instructions

Revainrating 3 out of 5

Causes Duet Wi-Fi processor overload and overheating.

Works but not on every control panel sold. The Duet processor starts to overheat immediately when connected to a 5V power supply. Endstop is used to detect float changes at 3.3V. This device switched 5V to endstop which overloaded the processor port. Do not connect +5V to the device (red wire). Use only ground (black wire) and locking pin (white wire). Works fine on my Duet wifi board connected this way.

Pros
  • Easy to read control panel
Cons
  • New competitors have appeared

Revainrating 5 out of 5

Works perfectly! in additive manufacturing products

It was just plug and play for me on my ender 3. I upgraded my board to skr mini v3 and added a btt tft35 v3 touch screen in front of my hand, which led me to buy this. There is a special place on the touchscreen for connecting a thread detector. The firmware configuration was easy to set up by selecting the function assigned. Not to mention that you can turn it on from the touchscreen menu. In general, after I made a glow sensor mounting bracket of my own design, it works great!

Pros
  • Good product for its price
Cons
  • fragile