Tigeracing Tie Down Anchors: Heavy-Duty Retractable Truck Bed D Rings for 1995-2018 Ram 1500 2500 3500 - 3000 LBS Capacity (Set of 4) Review

My rails had a diamond plate skid plate that was not installed properly and this product still works great with my truck. It gives me decent mounting points that don't always stick out, plugs up ugly pocket holes in the rail, and installs in about 2 minutes with an impact wrench. Very happy with this product!

These tie down anchors fit my 2008 Ram 2500 out of the box even though my truck has the new Line-X padding. I wasn't really looking forward to having to sand the blade to get them to fit. They fit great. They look and work great with LineX. Five fingers up. It took less than 5 minutes to install each mount. Just make sure you have a large Phillips screwdriver.

The quality of the product seems to be very good. Ease of installation. Simply remove the bolts and then tip into the stake pocket. Reinstall the screws. I installed a 2016 Ram 3500 with a plastic top guard. The only thing I would say is that the plastic paneling on the middle pockets is higher than the bed itself, so if you don't put anything underneath to raise it a bit, the piece will be too tight and result in the plastic comes on the side beds. .

Wanted to add brackets everywhere with no exposed hooks and brackets. These retractable mounts work perfectly without spoiling the look of the truck. Installation was very easy, although the two post holes that were next to the cab required modification. The holes for the cockpit poles appear to be slightly different on the Ram truck, but with a little adjustment the mounts worked fine. Very happy with the purchase.

Cutting the plastic paneling was not easy (cool monkey), but after it was opened, the anchor was inserted and fixed. If you don't have an insert, it only takes a minute to install both. I like the spring loaded bar that falls down when not in use. It's actually inside and also helps attach the plastic liner to the bed. I definitely recommend them. You simply loosen (or, in the case of the liner, remove) the top 2 Phillips head screws, tilt the base under the edge of the truck body and…

. I used it to fasten flip flops in a camper van with twist buckles (not recommended but was a great alternative for me). I didn't want other invasive straps so I chose these as a temporary solution - I don't use an RV very often. It worked great and they stayed an affix. After 6 hours of driving a 1400lb motorhome everything was cleaned up with no apparent problems. I still use them to secure cargo and large gear. So far no problem. Don't buy 2 or 1 packs, buy the cheap 4 pack as they are…

On our 2012 Ram we replaced the old duvet with a narrower one, leaving holes in the bed pockets. For a neater look and waterproofing of the bed, we looked for a bed pocket cover. The only items we could find for the Ram Truck were these tiger racing ties. We liked that it gave us both a clean finish and the functionality of additional mounts. It took a little "force" with a rubber mallet to install them - just to line them up exactly with the new bed rails. The rear attachment doesn't allow the