🚗 Maximize Ride Quality with Timbren DR1500DQ Suspension Enhancement System Review

We bought a new caravan that weighs 7800 pounds. Our 2014 Ram 1500 sat in the back and driving the truck was next to impossible on the road. Our friend suggested Timbrens as a solution. I'm glad he told us about it. They were very easy and quick to assemble. Just go to Youtube! It took about 15 minutes! After installation, the truck became completely different. Improved handling and resilience. It feels like it weighs 3/4 tons! If you're towing a heavy trailer that behaves uncontrollably behind

Every Dodge Ram owner should have these cars. As you know, the Dodge Ram has a soft ride, which is nice when empty, but when you've got a load it hangs low. I originally bought mine because I drive a trailer and wanted the truck to be level and not go downhill when going off-road. I also noticed that I was quite small while carrying a ton of rocks to bed. Now with timbral attacks, it runs smoothly all the time, even under load. The rubber stops were easy to install using soapy water and a 6…

I was skeptical about how easy these things are to install. It literally took 15 minutes. A jack, some small pieces of wood and some soapy water was all I needed. I won't lie, first I watched a few installation videos. After getting her inside as best I could, I drove to my 35-foot, 7,400-pound RV. Usually with my 2014 Ram 1500 the RV squats so much I expect the springs to pop (and I have an EZ Stabilizer System). To my surprise, it only squatted an inch, maybe 2. The best part was that my…

Very easy installation. I'm an average height woman and was able to install it easily with a small 2x4 piece of wood, a hydraulic jack and some soapy water. It only took me 20 minutes because the second one indicated problems and kept popping up as I lowered the jack. The instructions were easy, but many of the reviews gave good instructions as well. I lifted the frame, pulled out the old ones, dunked the rim of the new ones in soapy water, rotated them a little in a metal cup, and then used…

Installation: Jack up the rear at the hitch, leave the axle on the ground. I pulled out the fenders and tried to install the timbres but to no avail. Used some cool tricks with another brand. No luck with that. Lined them up, used two short pieces of 2x4, lowered the truck, raised it again to get a 2x4 - done. Do this once for each page and after 30 minutes the installation will be complete. Ride Test: Drove around the block to set up the suspension and looked. In my case the distance between…

Bought and installed a few weeks ago for my 2014 Ram 1500. I'm towing a 5000lb Aspen Trail that has about 600lb tongue weight. While the truck pulled and stopped the trailer normally, the stock fenders were a lot slack and it didn't seem like enough weight had shifted to the front end. After some research I decided that this would be the best option for me. Installation was easy. Old fenders fall out immediately. I've followed the path of many other reviewers by applying soapy water and then…

I bought these after looking for a solution to the significant sag in my 2019 RAM. I've attached before and after photos of the results, with the top photos being before installation and the bottom photos being after installation. A photo with all measurements serves as confirmation of my numbers. The installation was completed in less than 15 minutes. I ended up using a small amount of silicone grease to get it back in place, otherwise everything was very easy and straightforward. Before…