🔥 TORCH 1.5"-2" Rear Add A Leaf Lift Kit: Enhanced Suspension for 1995-2021 Toyota Tacoma 2WD 4WD TRD SR5 Review

The instructions are simple and clear. The stern raised about 2 cm. The ride got better. These Tacomas have premature wear on the rear springs, causing sag and sag. These additional leaf springs solved this problem. Factory hangers and dampers were reused. No problem. Came with cool stickers.

I installed them on a 1998 Tacoma. Previously, the truck had unnamed 3-inch leaf springs, but over time they dropped to about 2 inches, and then one of them broke. and some decals and lifted my truck to about the same height. Can't tell how they got the stock cart up as I only replaced broken blades. For the price they are very good and I am happy with them. They seem to drive well and I have loaded my truck with gear and they have held them for 3 months now.

I ordered myself to add a leaf in winter and planned to do it in spring. To be honest, I don't remember if the pins were in the box or if I lost the pin. I contacted Torch over the weekend and left a message. Don't expect a call before weekdays. Surprisingly they called a few hours later. Not only was the man helpful and changing pins without asking questions, he was a pleasure to deal with. Excellent customer service. Oh, adding the Leaf went well and gave me some of the lift I needed. There…

My 2006 Tacoma comes equipped with a 6" Fabtech raise that includes a 4" block and add-on at the rear. Since Tacomas are notorious for their weak leaf springs, they were eventually replaced, but the Fabtech extension plates were not reinstalled, leaving them a little low in the rear. It took me forever to understand why. These sheets corrected him perfectly. The hardest part of the installation was removing the rusty U-bolts from the axle. I highly recommend watching tutorial videos like I did.

They were packaged better than anything I have ever ordered. The sheets are of a very high quality and the extra stickers are always a nice touch. Installation took about 2 1/2 hours and the hardest and longest part was stapling the sheets together. I even used a jack along with two stands. The instructions that came were in place. This is the only lift I've made for the tacos so the back is higher than the front, but this is very useful for heavy loads. I would definitely recommend it to…

You can't go wrong with this product or company. I put on my first set and found that one side was almost an inch larger than the other. I'm not sure if my sheets were off or if there was some kind of inconsistency in the production. I personally see nothing wrong with them. So I contacted Torch through Amazon. They contacted me directly via email and gave me a direct line. I told them what my problem was and they immediately sent another set. I installed it and the problem got better. There's…