🏍️ High Performance Silver Short Offset Intake Manifold Carburetor with Gasket for 49cc, 60cc, 66cc, and 80cc Motorized Bicycles Review

This item is perfect for 80cc motorcycle engines. See, if your bike's frame is too small, leave the carburetor on the side

Still hasn't compensated my high performance carb enough to do away with the home made compensator I made. If you use an HP carburetor, you can choose a longer offset.

Works great! Fast delivery. The only thing is that they could take the opportunity to have a larger diameter. I would suggest it could be at least 4mm larger and still allow bolt play. Oh, and by the way, it's nearly impossible to use a wrench on a hex bolt on one side.

Good thing this product wasn't sawed and had a one piece metal dam just before the intake. I had to trim it before installing. It went well but was short as my carb hadn't left the frame yet. I ended up cutting off the last straight section, nailed the new end of the tube and soldered it together. works fine but not the clean look I was just looking for. But like most of these engines, most things get retuned when they're new anyway.

Works very well and fits well. The only problem you will face is the installation. The tube comes with two hex bolts. Because of the bend, you can tighten the screw with a regular allen wrench on one side, but you can't properly install the allen wrench on the other side. You will need a shorter Allen key or replace the screw with a regular screw. Otherwise the product works great. I gave it four stars because it was supposed to come with screws instead of hex screws.

Very prone to breakage from vibration. Welds tear easily. Carb weight makes it worse. I had 2 breaks. First, you'll hear the engine revs increase, the welds cracking, and air being sucked in... Go home right now because total failure is inevitable. You probably won't make it in time, because after that it will break quickly. Why can't anyone make a decent air intake just using a bent tube instead of that inefficient zigzag position?

This offset intake manifold was just what I needed to fit a 100cc engine into my frame. cm (actually 79 ccm). But there are two problems. First, the offset isn't enough to fit an air filter on my carb, and second, it's an odd size (diameter) so the carb doesn't fit snugly. At the moment I'm using tape around the pipe to give the carburetor a little tighter fit. But it's not exactly a long-term solution. These Chinese manufacturers don't have micrometers? ALL of these Chinese carburetors have a…