🔩 High-Quality US Forge Welding Stainless Steel MIG Wire .030 - 2-Pound Spool #00676 for Precise Welding Review

I used this on a stainless steel exhaust project I was working on and it worked great for thinner stock, some thicker and not only for welding stainless steel to stainless steel but a few spots as well where I had to weld stainless steel to mild steel.

. I set the head 1 lower than my welder suggested and it melted into the exhaust pipe very well. The welder was used in 220 mode.

Good product but not solid wire Really hard to know what to buy and the person on the phone spent about 20 minutes and I think that has one understood little. Flux in them but I think I got the right wire this time, I'll order something else

Good product but no solid wire to figure out what to buy and the person on the phone spent about 20 minutes and I think I understood a little. But I think I have the right wire this time, I'll order something else

I may have a bad coil but it doesn't weld very well with 100% AR at 35psi. Unfortunately I didn't measure him, but I suspect he was also too big because he had trouble eating or stopped eating altogether when he was hot. Even when applied, the sweat quality was terrible. When it ran out I replaced it with a Harris 0308LE2 308L spool which worked great with great weld quality with much less spatter and great feed. I will no longer buy US Forge/MESSER wire.

I ordered this stainless steel MIG wire to finish my stainless steel weld which I find difficult to TIG weld. Although I can TIG weld, this welding required me to attach round fittings to a round drum and there was a flange in the way. It was very difficult for me to get a good TIG weld, but I got the job done with this stainless wire in my MIG welder with no problem. I'm not sure how some of you experts can easily TIG weld some of these items, I give you my respects. I think I need more…

It will weld metal parts but that's all I can say as a complement to this welding wire. I used 75/25 as indicated. can be used and the welds are gray and look the same as if you were using regular MIG solid wire. Yes, maybe the composition is better for 304 stainless steel, but that too is up in the air. Maybe using this wire with trimix will give the right result. results, but the company claims that 75/25 is the preferred gas for this wire. If you really want to get a good result from a…