🔪 Uxcell 2-Inch Finger Router Cutting Tool Review

Let me start by saying that this drill press is difficult to use and set up. Second, the bond it makes is so strong that I couldn't get it to work with finished wood. It never came out right. However, I got it working with raw wood that was eventually cut to thickness. No matter how meticulous you are, it will never be perfect if you don't trim it down afterwards. I used it to laminate 1" pieces of raw poplar, then planed down to 5/8" for the boxes. This has created a beautiful seam that even…

may work for softwood but not hardwood. Cuts normally, smoothly, as it should be. However, no amount of tweaking can fix the fact that you can't tighten the connection tightly. It just doesn't fit. I've spent a few hours playing with this and figuring out what I'm doing wrong. It turns out it's a beat. The boards are stretched even before they are fully contracted. What a headache. I could tighten small joints (less than 2 inches) with great effort. If they were wider, they just wouldn't…

I read that another reviewer was annoyed with bad results because they thought the bit wasn't made right. I just spent an hour testing the resulting bit and realized that if you're getting poor results, this could be your technique. The wrong way to use this bit is to set it once, skip the board, then flip the counter board and skip it. The profiles will not match exactly this way, even if the bit is perfectly centered. The teeth are not designed to align when flipping boards. Instead, set the…