Header banner
Revain logoHome Page
uxcell turning woodworking carpentry drilling cutting tools logo

Uxcell Turning Woodworking Carpentry Drilling Cutting Tools Review

2

·

Average

Revainrating 3 out of 5  
Rating 
3.0
🪚 Industrial Drill Bits, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(4)
img 1 attached to Uxcell Turning Woodworking Carpentry Drilling Cutting Tools
img 2 attached to Uxcell Turning Woodworking Carpentry Drilling Cutting Tools
img 3 attached to Uxcell Turning Woodworking Carpentry Drilling Cutting Tools
img 4 attached to Uxcell Turning Woodworking Carpentry Drilling Cutting Tools

Description of Uxcell Turning Woodworking Carpentry Drilling Cutting Tools

Drilling Diameter: 6mm/0.24"; Total Length: 68mm/2.68". Shank Diameter: 10mm/0.39"; Drilling Depth: 40mm/1.57"; Turning: Right / Forward. Beveled edge leads to clean drilling of the diameter without any deviation. The optimized spiral design enables better guidance of the drill from start to finish. The brad point drill bit is suitable for drilling hardboard, plywood, chipboard and all natural hard and softwood.

Reviews

Global ratings 2
  • 5
    0
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 4 out of 5

Efficient Cutting Tools for Industrial Carpentry Projects

We recently started using these industrial drill bits for our woodworking projects and were pleasantly surprised with how efficient they were... USING this product, our team found that they easily cut through wood and helped us complete our projects in record time. The only con we experienced was that, at times the drill bits would get stuck in the wood which required us to remove and clean the bits before continuing. Overall, we highly recommend these cutting tools to anyone in need of…

Pros
  • versatile set of woodworking tools for turning, drilling, cutting, and carpentry
Cons
  • requires some skills and knowledge in woodworking to use them effectively

Revainrating 1 out of 5

Scrap: Drill

Brad Pin drills are designed so that the center starting point is higher than the two side cutting points. So the drill starts by drilling the middle point and eventually engages the two outer points cutting a hole of the desired diameter. With this tool, all 3 tips are sharpened to the same height, so the tip of the drill will wander and break all the wood if each of the 3 tips tries to pierce independently. Worst point drill bit I've used in over 30 years of woodworking. In the listing photo,

Pros
  • Power Tool Parts & Accessories
Cons
  • Crumpled