🚗 XO Vision Power Window Kit for 2-Door Windows Review

I purchased this kit and installed it on a 2007 Chevrolet/Chevy Cobalt LS. I made a YouTube video covering installation and tips (search for "Chevy Cobalt Power Window Rework" by ZVS Media). Wired through the door seal (radio circuit connection) and used a dremel to cut holes for the switches in the armrests in the driver and passenger side doors. So far I've only had one problem after 6 months of use and that was where the motor could detach from the door frame shortly after installation for…

very well made conversion kit but beware you need to change the fitment to your own car model. So make sure you have experience with both mechanical and electrical wiring. Since my dad wanted it to be a perfect fit, this project took 2 days, about 4-5 hours a day, and he took his time. All I can do is check your switches and motors every step of the way. Once fitted to his 1993 Toyota truck, they look like they came straight from the factory. The speed is also high, about 4-6 seconds to get on…

Purchased this kit for use on a 1990 Dodge W250 Diesel. Spent most of the install time trying to figure out which parts go with what as there were no instructions in the kit just a box of parts. But once that was done, it was a piece of cake from now on. If you've installed such kits before, it should be very easy. Unless. well, maybe it will take a little longer. I only had one problem with my kit. After installation, everything worked as it should on the driver's side, but the switch on the…

Installation was easier than expected. I suggest a spring loaded center punch and a 1/8th bit for the screws holding the motor and drivetrain. To wire, simply hold the plastic piece close to what it's connected to, then match the colors of the wires. The black one with the loop is grounded, and then connect the red main power supply with an extra fuse to the key in the circuit. The work is as good as the OEM in the S10 case. The passenger window runs a little slower due to the voltage drop…

I installed this kit on a 1998 Ford Van in just under 3 hours. I had previously removed the dashboard and door panels, so I knew what I was getting into. I looked at the "instructions" for a few minutes and found that they are basically useless other than telling you not to twist or kink wires from the motor to the window crankshaft. The instructions didn't mention anything about wiring. I learned more from the actual parts than the instructions. If you're mechanically inclined and have a good…

Three stars because it did the job in the end and is a great value over a legitimate factory rebuild but if I had to do it again I would buy the kit and pay the labor of a professional installer to install it. My car is 2009 Chevrolet Express 2500 Van. I will list my grievances below in case it helps sway anyone's decision. - NOT suitable for Universal. There is a slight dent on the door panel as I wasn't able to attach it all the way. Not too bad, it just means the panel isn't fixed in a…