XYZprinting RFPLCXUS05C Da Vinci Jr Review

I used it with a Da Vinci Jr. 3D printer. It often gets stuck in the printer even after I've cleaned the feeder (disassembled and cleaned the rollers thoroughly) and also cleaned the extruder nozzle by heating it to >200°C and then pulling the filament when the temperature reached 90° cooled was C. I did this several times but it stuck. The feeding tube has an inner diameter of 2mm, as do the two fittings. With a 1.75mm filament, a slight bend will cause it to jam and jam. The feeder is…

I rarely write reviews like this, but this one is an exception. I have purchased spools made with XYZ printing, but the chip embedded in the spool cannot be read by my mini XYZ Da Vinci printer. However, my printer can read chips from other coils I've purchased in the past, so I know my printer is fine. I tried to contact their customer service on their phone number but it was "closed due to Covid". several months in a row. Repeated letters to her go unanswered. Unfortunately the return period…

I am very dissatisfied. Just in the last few months I have bought several spools of XYZ filament. Each coil comes with its own axle ring. I finished my last print job last week as my previous spool ran out. In the end my old coil broke. Today I wanted to install my new coil and there was only a chip card, no axle ring. A check on the internet showed that other people had the same problem and most just use the old axle ring and replace the chip card. Of course, that won't work for me because I…