🔩 M-D Building Products 49010 Premium Aluminum Flat Saddle Threshold, 36 inches Length X 1-3/4 inches Width X 1/8 inch Height, Satin Nickel Finish, 36.25 inches Length x 2.61 inches Width x 1.75 inches Height Review

I chose this product because it's not shiny brass or silver that doesn't go well with everything else. It fits perfectly between the kitchen and utility room. Easy to install - came with nails that color matched well! I cut off a few inches from it but knew I had to do this when I placed the order. There are no cutting problems and no burrs are left at the end of the cut. The mounting nail holes are close enough together to lay perfectly flat after installation. Highly recommended, good quality

I was skeptical about ordering something like this online. It turned out to be a great purchase. Looks very good! I needed a transition piece from the dark hardwood floor to our carpet and couldn't find anything I liked at the local hardware stores. I decided to try it and am very happy with it. Easy installation: 1.). Measure the opening. Make sure this piece is at least the size of your doorway. It can be trimmed if necessary. 2.) Crop. 3.) Pre-drill the holes in the base to match the holes…

We have recently replaced all the old carpeting in our home with faux wood and needed some transition strips where the wood meets our existing tiled rooms. These silver aluminum transition strips look great on our cream tile and dark hardwood stain. Because they are aluminum, they can easily be cut with a standard miter saw. Don't forget to pre-drill the nail holes in the existing floor or sub-floor before nailing the floorboards: If you do not pre-drill, you can press in the adapter strips…

This is a very nice sill that I installed on a concrete slab for a door between my workshop and garage. I would have preferred the same threshold 1/8" taller and 1/4" wider, but that's not available. My door's sill opening is 31 inches, so I first cut a few inches from each end to get an exact fit (I used a radial handsaw, but a hacksaw will work too). For the installation I used the smallest diameter drill bit in stone. I need to drill holes to match the pre-drilled holes in the sleeper, deep…