🔩 Enhance Your Projects with Rok Hardware Standard Thread Screws: Reliable and Versatile Fastening Solution Review

Make sure you order the correct type of screw as you see in the picture description. I used screws to install the keyboard tray and it worked great. It's just screws, nothing more to say, but they worked.

I have used them in full extension drawer slides (16" and 14"). They are good quality and MUCH easier to use than the little screws that came with the drawers. They don't interfere with my drawer slides (I installed 6 pairs) with 12 screws per pair. I would buy again.

A lot of the small packages of screws you buy in big department stores are junk; Headbands and it's a hassle to get them back once that happens. These screws are great. I've used about 80 of these and haven't gotten it clear even if I quickly start the drill and apply pressure; It's also nice to have a small washer built into the head. I use them to attach some drawer slides as the screws that came with the slides are junk.

I needed these screws because I didn't have enough screws for a certain part of my dresser. After endless googling with the part number listed in the dresser instruction manual, I was led to this Amazon deal. I ordered them hesitantly as I was surprised at the quality and that they were exactly the screws I needed. Some people are unlucky when ordering items like this from Revain. But I will say that I am satisfied with my order and now have additional services if I encounter the same situation

Like many other buyers, I did not receive the correct quantity. I bought 500 and was cut down to 18. This appears to be a deliberate action by this seller at this time. The weight is too large to be accidentally caused by inaccurate equipment. I would advise anyone buying these to buy extra, calculate how much you want and return the extras. The only way to combat this behavior is to force unscrupulous sellers to pay for returns. The screws themselves are the typical low quality junk we'd…

4 stars out of 5 as the heads are slightly off center which can make alignment difficult. I think the gentleman who said they were 3/8 inch long misunderstood the product. Mine were almost 1/2 inch measured from the base of the head to the top. As for use with 1/2" drawer slides, the drawers I make are 13mm Baltic Birch plywood, sanded to about 15/32". The first slides I installed resulted in a noticeable bulge on the inside of the drawer but didn't protrude. Since they were so close I used…