Tools T Handle 4 Inch Capacity 12001 Review

' Arrived today via USPS mail. do not fully tighten it; the screw turns. ALSO this driver, when he reaches the end of his turn (by closing completely), he does not remain at the end of his turn. It returns to the "almost" fully tightened state. This screwdriver might be good for screws larger than 6-32, but I haven't tried this size yet. In fact, I'm returning it because I only bought it for a 6-32 thread that I need to do with a 6-32 tap.

I read reviews about this crank here. I've found buyers have trouble getting the wrench to grab and hold the smaller taps. I had problems too. I eventually found that this wrench/tap holder has multiple areas to hold the square end of different sized taps. The smallest taps need to be inserted deeper into this tool to fit the smaller square that lies deeper inside. The larger square you see when you look at the end of the wrench is for the larger 1/4 taps. Smaller sizes run lower. Nobody will…

Bought this tool to cut 2 holes for 6-48 bolts. I read the reviews and a lot of people seemed to say it was cheap junk, but I really didn't want to spend a ton of money on a tool that I would use once and probably never use again. The packaging says it requires a 0-1/4" drill bit. However, I wasn't able to tighten the chuck enough to hold the bit in place. Not even close, actually. It turned on tightened to a certain point and then just let go. twist without tightening. my guess is broken…