Review on PETG rod ABS Maker 1.75 mm, 1 kg, black by Kiril Panajotov ᠌

Name: PETG rod ABS Maker 1.75 mm, 1 kg, black
Item: PETG rod ABS Maker 1.75 mm, 1 kg, black
Rating: 2

July 06, 2023

Not at all what I expected.Terrible!

I strongly do not recommend it, if such quality is typical, then each print turns into a tape measure, whether there is enough bar of normal thickness for printing or the bar will get stuck. And the longer the print, the more likely it is not enough. Two six o'clock details screwed up

Pros

Plastic is good, prints flawlessly, but

Cons

In the middle of the coil, on a segment less than 50 meters long, there were 3 (! ) Sections with a bar thickness of more than 2 mm. Small fluctuations can still be overlooked, but a bar of such a thickness simply does not fit into the bowden and, at best, spoils the print. At worst, the bowden will have to be changed because it is impossible to pull out a well-seated or broken bar